General

General

Connection type

The Connection type determines how the stitches are created.

the first setting is sharp, thsi creates a normal satin stitch

the second is Zig Zag, this creates the Zig-Zag as shown

the last 2 settings only apply to Fill type stitching such as tatami

The first, Chisel creates an angle stitch at the end

the second Square, creates a 90 degree turn, This is a specialyu connection and can cause a lot of issues if you use a normal density

	Length of Chisel
	The lenght of the stitch in the chisel connector

	Max Density for Gradient
	What will be the maximum density value when applying a gradient density

	Gradient Density
	What type of variable density to create

	Overlap
	When columns end in the middle, some times there can be a gap in the thread, you can set the stitching to overlap by a number of stitches ot ensure this area is covered

	Short stitches
	Use short stitching to maintain density in a curve

	Auto density
	Automatically adjust density as stitch length changes